Zoom image View large image

Busch and Muller Secula Seatpost Rear Light - for E Bike only 6v DC input BML4e

In stock

£16.99 incl tax

The Secula E can be connected only to E-Bike systems which provide a 6V DC feed. The input voltage can also be obtained by connecting the rear light to one of the B&M headlights that convert a higher input voltage and output the required 6V DC for the rear. Optically, the Secula E appears the same as its dynamo counterpart, but the circuit board is different and the usage may not be interchanged.

- Can be connected to all DC power sources supplying 62V DC
- Can be powered by connecting to the Cyo E
- Can be mounted on the seat post or the rear stay
- Cannot be dynamo driven


Please note the following recommendations from Busch & Muller if you are planning to install your own E-Bike lighting system:

- Establish and/or measure the voltage on the cables or connecting point intended for the connection. Make sure this is within the parameters of the light specification
- Establish and/or measure the polarity of the above mentioned connection and make sure to connect respectively to the correct pole using the instructions and/or the + / - signs on the light
- If you are not able to establish either of the above, or are not sure then please refer to your local electric bike specialist to install the lights for you

Qty.:
  • Share it

  • Add to wishlist Add to compare list
    (0)
  • Subscribe

  • Enter your email below
    Submit