Zoom image View large image

Busch & Muller Toplight View Rear Rack Light - E Bike only 5-15v DC input BML6/7

In stock

£14.98 incl tax

The Toplight View E can only be connected to E-Bike systems which provide between 5 and 15V DC feed. The input voltage can also be obtained by connecting the rear light to one of the B&M headlights that convert a higher input voltage and output the required such as the Cyo E. Optically, the Toplight View E appears the same as its dynamo counterpart, but the circuit board is different and the usage may not be interchanged.

- Can be connected to all DC power sources supplying between 5 - 15V DC
- Can be powered by connecting to the Cyo E
- Can be mounted on the pannier rack - variable width fittingbolts - 50mm or 80mm
- Cannot be dynamo driven

Please note the following recommendations from Busch & Muller if you are planning to install your own E-Bike lighting system:

- Establish and/or measure the voltage on the cables or connecting point intended for the connection. Make sure this is within the parameters of the light specification
- Establish and/or measure the polarity of the above mentioned connection and make sure to connect respectively to the correct pole using the instructions and/or the + / - signs on the light
- If you are not able to establish either of the above, or are not sure then please refer to your local electric bike specialist to install the lights for you

Qty.:
  • Share it

  • Add to wishlist Add to compare list
    (0)
  • Subscribe

  • Enter your email below
    Submit